How to measure and photograph a part

A good measurement is half the job. This guide shows what to send us so the part fits the first time.

Updated · 2 min read

What you need

  • Callipers — the best tool for smaller dimensions. Digital callipers read to 0.1 mm and are sold in every DIY store.
  • A ruler or tape measure — for larger dimensions.
  • A phone — for the photos.

Which dimensions

  1. Overall size: length, width and height.
  2. Holes: diameter and position. Measure from the centre of a hole to the edge, or between the centres of two holes.
  3. Thicknesses: walls, rims and other important thicknesses.
  4. Mounting points: screw size (for example M4), clips and grooves.
  5. Everything that has to fit another part — these are the most important dimensions.

Write the dimensions in millimetres and mark on a photo or sketch which dimension goes where.

Tolerances: why a 10 mm hole will not fit a 10 mm pin

FDM printing is accurate to about ±0.2 mm. When two parts have to fit together, a small gap is left between them. When you order, tell us how the parts should fit:

  • tight — the part has to hold in place;
  • sliding — it moves but does not wobble;
  • loose — it goes in and out easily.

We allow for the gap ourselves when modelling. If the part has to fit something you already have, measure that as well.

How to take photos

  • Photograph the part from several angles: front, side, top, and close-ups of the mounting points.
  • Put a ruler or callipers next to it so the size can be seen in the photo.
  • Use a plain background and good light, without the flash.
  • Also photograph the place where the part goes — it often shows which dimension matters.
  • If the part is broken, photograph the break too.

When measuring is difficult

Curved surfaces, complex curves and gears are hard to measure from a photo. Then the surest way is to bring the part to us in Rakvere — we measure it ourselves.

Send it to us

The contact form takes up to 3 photos (each up to 5 MB). Add the dimensions, where the part is used and how many you need. If there is no 3D model, we model the part for you — see the 3D modelling page.